Table of Contents
blkcat - Display the contents of file system data unit in a disk image.
blkcat [-ahswvV] [-f fstype] [-u unit_size] [-i imgtype] [-o imgoffset]
[-b dev_sector_size] image [images] unit_addr [num]
blkcat
displays num data units (default is one) starting at the unit address
unit_addr from image to stdout in different formats (default is raw). blkcat
was called dcat in TSK versions prior to 3.0.0.
- -a
- Display the contents
in ASCII
- -f fstype
- Specify image as a specific file type. If ’swap’ is given
here, the image will be displayed in pages of size 4096 bytes. If ’raw’ is
given, then 512-bytes is used as the default size. The ’-u’ flag can change
the default size. Use ’-f list’ to list the supported file system types. If
not given, autodetection methods are used.
- -h
- Display the contents in hexdump
- -s
- Display statistics on the image (unit size, file block size, flag and
number of fragments).
- -u unit_size
- Specify the size of the default data unit
for raw, blkls, and swap images.
- -i imgtype
- Identify the type of image file,
such as raw. Use ’-i list’ to list the supported types. If not given, autodetection
methods are used.
- -o imgoffset
- The sector offset where the file system starts
in the image.
- -b dev_sector_size
- The size, in bytes, of the underlying device
sectors. If not given, the value in the image format is used (if it exists)
or 512-bytes is assumed.
- -v
- Verbose output to stderr.
- -V
- Display version.
- -w
- Display
the contents in an HTML table format.
- image [images]
- The disk or partition
image to read, whose format is given with ’-i’. Multiple image file names can
be given if the image is split into multiple segments. If only one image
file is given, and its name is the first in a sequence (e.g., as indicated
by ending in ’.001’), subsequent image segments will be included automatically.
- unit_addr
- Address of the disk unit to display. The size of a unit on this
file system can be determined using the -s option.
- num
- Number of data units
to display.
The basic functionality of blkcat can also be achieved using
dd. To determine which inode has allocated a given unit, the ifind(1)
command
can be used.
# blkcat -hw image 264 4
or
# blkcat -hw image 264
ifind(1)
Brian Carrier <carrier at sleuthkit dot org>
Send
documentation updates to <doc-updates at sleuthkit dot org>
Table of Contents